How to better use woodworking carving machine and precautions

For those sculptured objects with irregular shapes, they seem to have been fixed tightly on the surface, and they will shake back and forth when they are under downward pressure. At this time, you can try to pad some waste material under the object to increase friction. In addition, keep the package of the article. Although the object is irregular in shape, its own package may be very regular and easy to be fixed. With a small belt, the irregular object is easy to be fixed. Or try to use tools to fix the regular parts and discard the irregular parts.
With the development of the times, woodworking carving machine products are more and more favored by consumers. During the carving process, we need to pay attention to the operating skills of woodworking carving machines, so that the carved objects will not be misplaced, so as to avoid the damage of the carved objects to the greatest extent.
Check whether the pliers or chuck selected by the woodworking engraving machine are used incorrectly? At the same time, the wear of the pliers or the clamp head of the woodworking carving machine will also lead to the dislocation of the carved objects. If the pliers or clamp head is too tight, the carved object will pop up at the moment when the cutter head contacts the carved object.
For carving plastic patterns, you can stick the transfer tape on the back of the carved object, spray the side with the tape with liquid spray, and then stick it on a surface that can be discarded. In this way, you can avoid using double-sided tape and leaving a surface that is difficult to clean. Because the transfer tape is easy to peel off and clean. Special engraved tape is used. One side of the tape is more sticky than the other side, so the plate can be moved or replaced at will.
If the downward pressure on the carved object is great, consider whether you must use a conical nose. If the pressure on the diamond head of the woodworking carving machine is too great during the carving process, the pressure on the side of the tool will cause the carved object to move. If an incorrect diamond knife is used, the same problem will be caused. A 90 or 100 degree diamond knife will go deep into the material carving and make the material move during the carving process.