Language
- English
- 中文站

Cutting mode of round steel cutter

Release time:

2022-06-01 08:21

After decades of development, China's construction round steel cutting machine market has also formed. At present, there are many kinds of round steel cutting machines produced and sold in the market. We can classify them according to the characteristics of each mechanism composed of the equipment. Next, we will mainly introduce which round steel cutting machine is used according to the cutting method.
Cutting mode of round steel cutter:
1. Hammer cutting mode
Suitable for medium and small diameter round steel, with continuous and large working noise. Continuous cutting is easy to occur, and the foot fixing error is smaller. It is suitable for medium and low speed round steel cutting machine and occasions requiring high sizing accuracy.
2. Flying shear cutting mode
It is suitable for large and medium diameter round steel, with large working noise and discontinuity. The sizing accuracy is not high, but there is no continuous cutting phenomenon. Suitable for high speed round steel cutting machine.
3. Hydraulic cut-off mode
It is suitable for large and medium diameter round steel with low working noise. No continuous cutting. It is suitable for round steel cutting machine with low speed.
The above is an introduction to selecting the round steel cutting machine according to the cutting method. I hope it will be helpful to the majority of users.

Mechanics,mechanical equipment

Common problems and solutions of round steel shears

Misunderstanding in purchasing round steel cutter

Common problems and solutions of round steel shears

Misunderstanding in purchasing round steel cutter

Recommended News

The installation and setting of the cutter shall not be careless

2021-09-15

Because the installation environment and space size of different users are different, we should combine different house types and different conditions to create a customized installation scheme for customers. Do not stay the same, otherwise it may occupy too much space, resulting in too small space, and will greatly affect the aesthetic degree. Therefore, the installation scheme should be adapted to local conditions and different from person to person.

Replacement method of friction plate of cutting machine

2021-09-15

After the friction plate of the cutting machine is worn, the gap between the blades of the cutting machine will increase. If it is not replaced, the gap between the blades will be large, which is easy to damage the blades. In serious cases, the machine head may be jacked and the side cover may be jacked.